Controller Setup - Optional Feature
2 minute read
With this mod list, you are able to use a controller and access nearly all of the required keybinds through the use of a few optional mods. You shouldn’t have any issues performing this process on existing saves.
Switching to Controller
Follow these steps to switch from Keyboard and Mouse to Controller;
In the left pane of Mod Organizer, scroll all the way to the bottom, and find the “CONTROLLER SETUP (OPTIONAL)” separator. You will find three mods in this separator.
DISABLE the “Keyboard Keybinds” mod, and ENABLE the “Gamepad Plus Plus” and “Complete Controller Setup” mods.
Leave the MCM Recorder preset mods untouched.
At this point, you should load the game, and load into your save. Then, follow the below instructions
Open the pause menu, and navigate to Controls. Reset your controls to default (key/button to do so is shown at the bottom of the GUI)
Open the MCM menu named MCM Recorder, and click on the “AurbaesenceController” preset. Use the Run option, then close the MCM.
Re-open the MCM, open the Gamepad++ MCM menu. Navigate to Presets & Info > Load Preset > Aurbaesence. After selecting Aurbaesence, close the MCM menu completely.
Re-open the MCM menu, and open Gamepad++ once again. Open the Keys & Settings page, press OK to the prompt, then close the MCM menu. If you don’t see a prompt, simply close the MCM menu.
Confirm that the the controller bindings are working as listed on the bindings documentation. Now, you are ready to use your controller!
Switching back to Keyboard/Mouse
If you wish to move back to the keyboard primarily, you must follow the below steps;
In the left pane of Mod Organizer, scroll all the way to the bottom, and find the “CONTROLLER SETUP (OPTIONAL)” separator. You will find three mods in this separator.
ENABLE the “Keyboard Keybinds” mod, and DISABLE the “Gamepad Plus Plus” and “Complete Controller Setup” mods.
In game, open the MCM menu, then open the MCM menu named MCM Recorder, and click on the “AurbaesenceKeyboard” preset. Use the Run option, then close the MCM.
This will return the keybinds to their original state.